MMA Cage Fence Mesh: Vinyl-Coated Chain Link, Wire Thickness and Safety Rules

An MMA cage fence must keep fighters in under state commission rules, and most use vinyl-coated chain link. Wire, mesh and coating compared.

By Stéphane "Smash" CoignonPublished 4 min read
MMA Cage Fence Mesh: Vinyl-Coated Chain Link, Wire Thickness and Safety Rules

The fence is the part of an MMA cage fighters touch most: they push off it, get pinned against it and use it to stand back up. For a gym owner, the decision comes down to the type of mesh, the wire thickness and the coating over the steel. State athletic commission rules spell out what the fence must do and leave those choices to the manufacturer.

What Commission Rules Require From an MMA Cage Fence

In Georgia, Rule 85-3-.02 says the fighting area must be enclosed by a fence that will not allow a fighter to fall out or break through it onto the floor or spectators, and names vinyl coated chain link fencing as an example. New Mexico (15.6.20.10 NMAC) and Ontario (Professional Combative Sport Rules, section 2.5) use the same standard and the same example.

All three texts require every metal part of the fenced area to be covered and padded and not abrasive to the fighters. New Mexico and Ontario also ban any obstruction on the fence. Posts must be metal, no more than 6 inches (15.2 cm) in diameter under Georgia and New Mexico rules, and reach at least 58 inches (1.47 m) above the canvas under Georgia and Ontario rules.

To compare those requirements with the models available to gyms, our MMA cages and rings page lists the fence, frame and floor of every cage in the catalog.

Free MMA newsletter The Corner, every Monday Fight times and where to watch, your pick, the right gear for your budget, one technique explained. One email a week, one-click unsubscribe. Your data

Coated fence wire is galvanized steel with a PVC layer on top. At Hoover Fence, a U.S. fence maker, the steel core is hot-dip galvanized, coated with a bonding agent, covered in PVC and then baked so the coating fuses to the wire. Hoover warrants that fabric for 15 years against rust and corrosion.

Vinyl-coated chain link is the standard for competition cages. The UFC Octagon uses chain link coated with black vinyl, 6 feet (1.8 m) high, with foam padding along the top of the fence and between each of its eight sections. Gym cages on the market follow the same design: Combat Sports lists vinyl-coated chain link sections on its CAGE3 model, and Kenel describes the fence on its Pro Octagon cage as vinyl-coated chain link built to resist deformation and cracking.

According to Wikipedia, some cages replace the metal fencing with a net.

Wire Gauge and Mesh Size

Wire thickness sets how stiff the fence feels when a fighter is pinned against it. Combat Sports lists 9-gauge wire on its CAGE3 and says its heavy-duty fence minimizes bowing during exchanges. Standard chain link comes in a 2-inch (5.1 cm) mesh at Hoover Fence, measured between two parallel sides of the diamond.

ModelWireCoatingHeight
Pro cage (MMA Official catalog)0.15 in (3.8 mm)About 0.24 in (6 mm) thick once coatedVaries by model
Sparring cage (MMA Official catalog)0.09 in (2.4 mm)Not specifiedVaries by model
Pro cage wall (MMA Official catalog)0.17 in (4.2 mm)0.06 in (1.5 mm) polymer6 ft (1.83 m) segments
Combat Sports CAGE39 gaugeVinyl6 ft (1.83 m) panels
Kenel Pro OctagonNot specifiedVinyl6 ft or 6.6 ft (1.8 or 2 m)
UFC OctagonNot specifiedBlack vinyl6 ft (1.8 m)

In the MMA Official catalog, Pro cages use heavy 0.15-inch (3.8 mm) wire, about 0.24 inch (6 mm) thick once coated, on 3.5-inch (89 mm) round tubes. Sparring cages step down to 0.09-inch (2.4 mm) wire on 2-inch (5 cm) square tubing: they cost less and work for classes, but hold up less well to daily use by heavier fighters. Wire and frame go together, as covered in our guide to the MMA cage frame, galvanized vs. painted steel.

Fingers and Toes in the Fence: What the Rules Say

New Mexico’s rule 15.6.20.15 lets a fighter put their hands on the fence and push off it at any time, and place their feet on the cage with their toes through the fencing material. It becomes illegal when fingers or toes go through the cage, grab hold of the fence and start to control either fighter’s position.

In New Mexico, the referee may take a point if the foul had a substantial effect on the fight; if the fouling fighter gains a superior position, the referee restarts both fighters standing in a neutral position. In Georgia, holding or grabbing the fence draws a single warning first, then a penalty that can mean a point deduction or disqualification.

How to Choose the Fence for a Gym Cage

A gym running recreational classes can start with 0.09-inch (2.4 mm) wire, as on the catalog’s Sparring cages. A gym training heavy fighters every day or preparing competitors should look at coated wire from 0.15 to 0.17 inch (3.8 to 4.2 mm), as on the Pro cages and the Pro cage wall. Either way, every metal part of the enclosure has to be covered and padded, as the commission rules above require.

On our MMA cages page, you pick the model, size and options and receive a detailed price estimate as a PDF. Listed prices exclude tax, shipping and installation.

Frequently Asked Questions

Does an MMA Cage Fence Have to Be Vinyl-Coated?

Georgia, New Mexico and Ontario require a fence that keeps fighters in and name vinyl-coated chain link as an example. They also require every metal part to be covered, padded and not abrasive.

What Wire Thickness Should a Gym Cage Use?

The MMA Official catalog uses 0.09-inch (2.4 mm) wire on Sparring cages built for classes and 0.15-inch (3.8 mm) wire on Pro cages built for heavy daily use. The Pro cage wall uses 0.17-inch (4.2 mm) wire with a 0.06-inch (1.5 mm) coating.

Can a Fighter Grab the Cage During a Fight?

No. In New Mexico, pushing off the fence with the hands or putting the toes through it is legal, but grabbing it with fingers or toes to control position is a foul, punished by a point deduction when it has a substantial effect on the fight.

07 · Sources

Written by

Stéphane "Smash" Coignon

Professional MMA fighter who competes mostly at heavyweight and can cut down to middleweight. Born in Amiens, France, and based in Osaka, Japan, where he teaches kickboxing, he is MMA Official's certified gear tester and writes fight breakdowns and equipment reviews. Our methodology