A gym MMA cage takes a beating every day: takedowns into the fence, fighters walking up the wall and, on portable models, repeated setups and teardowns. The frame, meaning the posts, the top and bottom rails and the gates, carries all of that load. Its rust protection, the diameter of its tubes and their wall thickness decide how long it lasts.
Serious spec sheets list all three values. The MMA cages and boxing rings page on this site shows them model by model, with a manufacturer price for every size.
What Athletic Commission Rules Say About the Frame
U.S. athletic commissions regulate cage posts. In Michigan (Rule R. 339.205a, last amended March 21, 2023) and Ohio (Rule 3773-7-11, effective July 1, 2010), cage posts must be metal, no more than 6 inches in diameter, and extend 5 to 7 feet above the cage floor. They must be properly padded in a manner approved by the commission.
Both rules also require every metal part on the interior of the cage to be covered and padded and not abrasive to the fighters. The fence must keep a fighter from falling out or breaking through, and Ohio gives vinyl-coated chain link as an example. Neither rule sets the steel finish or the tube wall thickness, which are left to the manufacturer and the buyer.
Galvanized vs. Painted Steel: Rust Protection
Hot-dip galvanizing dips the steel in molten zinc. The EN ISO 1461 standard, in its 2022 edition, sets a minimum zinc thickness based on steel thickness. For walls from 1.5 to 3 mm (about 0.06 to 0.12 inch), the range used for gym cage tubing, it requires an average of 55 microns and at least 45 microns at any point, according to the galvanizers associations of the UK and Ireland. Above 6 mm of steel, the average minimum rises to 85 microns.
According to the UK Galvanizers Association, barrier protection lets corrosion start as soon as the barrier is breached. Zinc also protects exposed steel galvanically at a scratch or a cut edge, with no sideways corrosion around the damage.
You can still paint or powder coat galvanized steel. This duplex system adds color, extends service life or protects steel in very aggressive environments, the same association says. The American Galvanizers Association states that a duplex system can last 1.5 to 2.3 times the combined lifetimes of the two coatings used alone.
The corrosivity scale puts heated buildings with clean air, such as offices, schools and shops, in category C1, the lowest. A building with almost permanent condensation and heavy pollution falls into category C5-I. In drier inland areas of the UK, outdoor zinc loss is under 1 micron per year.
Tube Size and Wall Thickness in the Site Catalog
The catalog splits frames into two families. Sparring models use 2 x 2 inch (5 x 5 cm) square tubing with a 2 mm wall and light mesh made of 2.4 mm wire. Pro models move to round tubing, 1.9 inches (48 mm) on the top and bottom rails and 3.5 inches (89 mm) on the uprights, with a 3 mm wall and heavy mesh made of 3.8 mm wire. IMMAF models use a galvanized steel tube structure measuring 40 x 60 mm (1.6 x 2.4 inches) with a 2 mm wall.
| Model | Frame | Wall | Starting price (excl. tax) |
|---|---|---|---|
| Light Sparring portable octagon | 2 x 2 in square tube | 2 mm | $2,570 (€2,333) |
| Sparring floor octagon | 2 x 2 in square tube | 2 mm | $3,158 (€2,867) |
| Light Pro portable octagon | 1.9 and 3.5 in round tubes | 3 mm | $5,250 (€4,767) |
| Pro floor octagon | 1.9 and 3.5 in round tubes | 3 mm | $6,233 (€5,659) |
| IMMAF floor octagon | 1.6 x 2.4 in galvanized steel tube | 2 mm | $13,962 (€12,677) |
The 3.5 inch uprights on Pro models sit well under the 6 inch cap in the Michigan and Ohio rules. The catalog describes the 2 inch square tube as fine for classes and less suited to heavy daily use by big fighters. Galvanizing is listed on the IMMAF spec sheets; for other models, ask about the surface finish when you request your estimate. The Pro MMA ring in the catalog has a painted structure, available in several colors.
How to Make a Gym Cage Frame Last
A torn pad that exposes a post puts the cage out of line with the Michigan and Ohio rules, which require all interior metal to be covered and padded. Padding has its own thickness and density thresholds, covered in our guide to MMA cage padding. Cage size, which sets the length of every rail, is covered in our article on MMA cage dimensions.
On galvanized steel, a deep scratch stays protected by the surrounding zinc, according to the UK Galvanizers Association. For a portable cage that is set up and taken down often, the segment locks on the Light Pro portable octagon keep the cage in shape even during hard sparring, according to its spec sheet.
On the MMA cages page, you pick the model, size and options and receive a priced estimate as a PDF. Prices in U.S. dollars are converted from the euro manufacturer price and exclude sales tax, delivery and installation.
Frequently Asked Questions
Why choose a galvanized steel cage frame?
Zinc acts as a barrier and also protects exposed steel at a scratch or cut edge, with no sideways corrosion, according to the UK Galvanizers Association. EN ISO 1461 requires an average of at least 55 microns of zinc on a 1.5 to 3 mm wall.
How thick can cage posts be under the rules?
In Michigan and Ohio, cage posts must be metal, no more than 6 inches in diameter, and extend 5 to 7 feet above the cage floor. They must be padded.
Can you paint a galvanized cage?
Yes. A duplex system adds color and extends service life. The American Galvanizers Association puts its lifespan at 1.5 to 2.3 times the combined lifetimes of paint and galvanizing used alone.




